Watch it draw itself · tap to replay
How to Draw a Wizard Hat
Draw a wizard hat in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the tall cone.
Step 1: The tall cone
Start below the middle. Draw a line up to a point near the top, then down the back, stopping level.
Tip The point flops over a bit, like a sock.
Step 2: Bottom of the cone
Start at the bottom of the front line. Draw a gentle smile curve across to the bottom of the back.
Step 3: The wide brim
Start on the left of the cone. Swing a big wide oval out, under, and round to the right side.
Step 4: Thick brim
Drop a short straight line down from each end of the brim. Join them with a big smile curve underneath.
Tip Keep the gap the same all the way round.
Step 5: Two big eyes
Low on the cone, draw 2 big round eyes a finger apart, with a black dot and shine in each.
Step 6: Smile and cheeks
Draw a deep U smile from under one eye to under the other. Add an oval cheek on each side.
Step 7: The ribbon band
Start on the left of the cone, 2 fingers up. Draw a sagging curve across and stop on the right.
Step 8: Stars and a moon
Above the eyes, draw 2 little 5-pointed stars and a tiny crescent moon. None of them touch the eyes.
Step 9: Twinkles and a table
Draw a 4-point twinkle at the top right and a smaller one on the left. Add a table line below.
Step 10: Red band, yellow stars
Colour the ribbon band red, and the stars, moon and twinkles yellow.
Step 11: Colour the hat blue
Colour the cheeks pink, then the hat blue around the band, stars, moon and cheeks. Leave the eyes white.
Your finished drawing
Follow the steps above and this is where you end up: a wizard hat, drawn by you.
Every step in one picture
