Watch it draw itself · tap to replay
How to Draw a VR Headset
Draw a VR headset in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the visor.
Step 1: The visor
Across the middle of your paper, draw a long flat goggle shape with a small nose dip at the bottom.
Tip Make it more than twice as wide as it is tall.
Step 2: Two big eyes
On the visor, draw 2 big egg eyes a little apart, with a black dot and a shine in each.
Step 3: Smile and cheeks
Under the eyes in the middle, draw a small U smile. Add a flat oval cheek below each eye.
Step 4: Soft cushion
Start at the visor's lower left corner. Draw a soft rim up, over the top, down to the other corner.
Tip That's the soft cushion that sits on your face.
Step 5: Head strap
Start on the cushion's left side. Swing 2 lines out, round behind and back in to the right side.
Tip The strap goes round your head, so it curves back behind the visor.
Step 6: Top strap
From the middle of the cushion top, draw a thin strap straight up to the head strap behind.
Step 7: Shine and sparkles
Start near the visor's left end and draw a short curved shine line up. Add 3 little sparkles around.
Step 8: Shadow
Under the visor, draw a long flat oval for the shadow, tucked behind the bottom edge.
Step 9: Grey straps
Colour the head strap, the top strap, the cushion rim and the shadow grey.
Step 10: Pink cheeks
Colour the cheeks pink.
Step 11: Slate visor
Colour the visor slate, going around the eyes and cheeks. Leave the eyes white. Ready to play!
Your finished drawing
Follow the steps above and this is where you end up: a VR headset, drawn by you.
Every step in one picture
