Watch it draw itself · tap to replay

How to Draw a Toolbelt

14 steps · Medium · about 11 min

Draw a toolbelt in 14 easy steps, about 11 minutes. Free, with a printable worksheet.

Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the belt.

Step 1: The belt
Across the top half, draw a long thick belt that dips a little in the middle, like a smile.
Tip Leave room under the belt for the pouches.
Step 2: Big pouch
Under the middle of the belt, draw a big pouch hanging down, with bulging sides and a round bottom.
Step 3: Two big eyes
In the middle of the big pouch, draw 2 big egg eyes with a black dot and a white shine.
Step 4: Smile and cheeks
Under the eyes, draw a U smile. Add a small oval cheek beside each end.
Step 5: The buckle
Draw a square buckle over the middle of the belt, with a square hole and a pin across it.
Step 6: Flap and stitches
Above the eyes, draw a U flap across the big pouch from side to side. Add stitch dashes along it.
Step 7: Two small pouches
Near each end of the belt, draw a smaller pouch over the belt, with bulging sides and a round bottom.
Step 8: The hammer
Out of the left pouch, draw a handle poking up past the belt, with a claw hammer head on top.
Step 9: The wrench
From the right pouch, draw a wrench handle up past the belt, topped by a round head with a bite.
Step 10: Tape measure and ground
On the right pouch, draw a square tape measure with a circle and a tab. Draw a ground line across.
Step 11: Yellow tape, pink cheeks
Colour the tape measure yellow and the cheeks pink.
Step 12: Tan pouches
Colour the 3 pouches tan, around the cheeks and the tape measure. Leave the eyes white.
Step 13: Grey tools, red handle
Colour the buckle frame, the hammer head and the wrench grey. Colour the hammer handle red.
Step 14: Brown belt
Colour the belt brown around the pouches, tools and buckle, and in the buckle hole. Your tool belt is ready!