
Watch it draw itself · tap to replay
How to Draw a Spring
Draw a spring in 12 easy steps, about 9 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the top plate.
Step 1: The top plate
Near the top of your paper draw a flat rounded bar, about a hand wide.
Step 2: The bottom plate
Near the bottom of your paper draw another flat bar the same size, straight below it.
Step 3: Two front loops
Under the top plate draw 2 thick smile bands, one below the other. Each starts high on the left.
Tip Leave a gap three bands tall between them.
Step 4: One more loop
Draw 1 more smile band below, a little closer to the one above. Stop above the bottom plate.
Step 5: Back of the loops
From each right tip draw a band arching back over to the left. It tucks behind, then runs down.
Tip Two run down to the next band. The last runs down into the bottom plate.
Step 6: Top link
Draw a short band from the top plate down to the left tip of the first loop.
Step 7: The floor
Draw a floor line along the bottom of the bottom plate, from well left to well right.
Step 8: A shadow
Draw a flat oval shadow on the floor line, a little wider than the bottom plate.
Step 9: Sparkles
Draw 2 small sparkle stars, one on each side of the coil.
Step 10: Yellow sparkles
Go over your lines, then colour the 2 sparkles yellow.
Step 11: Blue loops
Colour the 3 thick front bands light blue.
Step 12: Grey plates, dark backs
Colour both plates and the shadow grey and the 4 back bands dark grey. Your spring is done!

Your finished drawing
Follow the steps above and this is where you end up: a spring, drawn by you.
Every step in one picture
