Watch it draw itself · tap to replay
How to Draw a Screwdriver
Draw a screwdriver in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the handle.
Step 1: The handle
Near the top draw a fat handle with a round top and straight sides, narrowing to a flat bottom.
Tip The flat bottom is a thumb wide.
Step 2: A happy face
High in the handle draw 2 big round eyes with black dots. Add a wide U smile under them.
Step 3: The metal collar
Start at the handle's bottom-left corner. Draw a short flat box under it and stop at the bottom-right corner.
Step 4: The shaft
From the bottom of the collar draw 2 long lines straight down, a finger apart. Stop near the bottom.
Step 5: The flat tip
Start at the bottom of the left shaft line. Flare out, go down to a flat bottom, and back up.
Step 6: Rosy cheeks
Draw a small oval cheek out beside each end of the smile.
Step 7: The ground
Start left of the tip and draw a long ground line across, right under the flat tip.
Step 8: A screw
Right of the tip draw a screw lying down, with a little box head and 3 slanted dashes.
Step 9: Peach and grey
Colour the cheeks peach, and the shaft, the flat tip and the screw light grey.
Step 10: Red handle
Colour the handle red around the peach cheeks. Leave the eyes white.
Step 11: Dark grey collar
Go over your lines, then colour the metal collar dark grey. Your screwdriver is done!
Your finished drawing
Follow the steps above and this is where you end up: a screwdriver, drawn by you.
Every step in one picture
