Get the app: iPhone Android
squigglingsToday’s squiggleThemesSaved
Finished drawing of a laminator

Watch it draw itself · tap to replay

How to Draw a Laminator

14 steps · Medium · about 11 min

Draw a laminator in 14 easy steps, about 11 minutes. Free, with a printable worksheet.

Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the machine.

Print

  1. Step 1: The machine

    Above the middle of the page draw a long low box with soft corners, nearly as wide as the paper.

  2. Step 2: Two big eyes

    In the middle of the box draw 2 big egg eyes. Colour a big black dot in each.

  3. Step 3: Smile and cheeks

    Under the eyes draw a wide U smile, and a flat oval cheek beside each eye.

  4. Step 4: The slot

    Along the bottom of the machine draw a long thin box for the slot, much wider than the face.

  5. Step 5: The glossy sheet

    A big sheet slides out of the slot. Draw its sides sloping down and out, then a round-cornered bottom.

    Tip Make the sheet wider than half the machine.

  6. Step 6: The paper inside

    Inside the sheet draw the paper's 2 sides and bottom edge. Draw 3 writing lines on it.

    Tip The top of the paper is still inside the machine.

  7. Step 7: Shine dashes

    Near the paper's top right corner draw 2 slanted dashes for the glossy shine.

  8. Step 8: Lid and lights

    Near the machine's top draw a lid line from side to side. Under its right end draw 2 round lights.

  9. Step 9: Table lines

    Start near the left edge. Draw a line under the machine, another under the sheet. Stop near the right edge.

  10. Step 10: Sparkles

    Draw 3 little 4-point sparkles beside the sheet, not touching it.

  11. Step 11: Cream paper, yellow sparkles

    Colour the paper cream and the sparkles yellow.

  12. Step 12: Sky sheet

    Colour the sheet's edge light sky blue, going around the cream paper.

  13. Step 13: Pink cheeks, green lights

    Colour the cheeks pink and the 2 lights green.

  14. Step 14: Slate machine

    Go over your lines. Colour the machine slate grey around the face and lights, and the slot black.

    Tip Leave the eyes white.

Your finished drawing

Follow the steps above and this is where you end up: a laminator, drawn by you.

Every step in one picture

How to Draw a Laminator step by step: all 14 steps in one picture

More to draw

More things to draw · Every squiggling, A to Z