
Watch it draw itself · tap to replay
How to Draw a Hot Water Bottle
Draw a hot water bottle in 13 easy steps, about 10 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the bottle.
Step 1: The bottle
In the middle draw a tall rounded rectangle with 4 soft corners, for the flat rubber bottle.
Tip Leave room above it for the neck and below it for a small tab.
Step 2: Two big eyes
In the middle of the bottle draw 2 big egg eyes. Colour a big black dot in each.
Step 3: Smile and cheeks
Under the eyes draw a wide U smile, and an oval cheek below each eye, out to the side.
Step 4: Funnel neck
Draw a funnel neck on top, wide at its top. Add a rim line from side to side.
Step 5: The stopper
In the top of the funnel draw a small round-topped stopper. Add a line across it from side to side.
Step 6: Hanging tab
Under the bottle draw a small rounded tab. Draw a flat oval hole in it for hanging.
Step 7: The seam
Inside the bottle draw the same rounded shape again, a little way in from the edge.
Step 8: Ribs
Draw 2 lines across above the face and 3 below it. Start and stop each one on the seam.
Step 9: Warmth lines
Draw 2 short wiggly lines rising beside the neck, one above each shoulder.
Step 10: Sparkles
Draw a few little 4-point sparkles around it to make it shine.
Step 11: Pink and yellow
Go over your lines, then colour the cheeks pink and the sparkles yellow.
Step 12: Red bottle
Colour the bottle, neck and tab red, around the cheeks and the hole. Leave the eyes white.
Step 13: Blue stopper
Colour the stopper blue. Your hot water bottle is done!

Your finished drawing
Follow the steps above and this is where you end up: a hot water bottle, drawn by you.
Every step in one picture
