
Watch it draw itself · tap to replay
How to Draw a Glow Stick Bracelet
Draw a glow stick bracelet in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the ring.
Step 1: The ring
In the middle of your paper draw a big oval as wide as your hand, then another just inside it.
Tip Snap a glow stick, bend it round, click the ends together. It glows!
Step 2: The connector
On the front left of the ring draw a small fat block across the tube, where the 2 ends join.
Step 3: Twinkles
In the air above the ring draw 2 little four-point twinkles, one on each side, for the glow.
Step 4: Glow dashes
Round the top of the ring draw 4 short dashes pointing out, like little rays of light.
Step 5: More dashes
Add 2 more glow dashes, one on each side of the ring.
Step 6: A second one
Just right of the big ring, not touching it, draw a smaller flat oval with a smaller one inside.
Step 7: Its connector
On the back right of the small ring draw a tiny slanted block across the tube.
Step 8: The table
Draw a table line from far left to far right, just touching the bottom of both rings.
Step 9: Yellow glow
Colour the twinkles yellow. Colour a soft yellow glow along both sides of each tube. Leave tubes and connectors white.
Step 10: Glowing pink
Colour the small ring's tube pink, around its white connector and inside the yellow glow.
Step 11: Glowing green
Colour the big ring's tube green around its connector. Leave the middle of each ring plain. You are done!

Your finished drawing
Follow the steps above and this is where you end up: a glow stick bracelet, drawn by you.
Every step in one picture
