
Watch it draw itself · tap to replay
How to Draw a Dogwood Flower
Draw a dogwood flower in 12 easy steps, about 9 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the twig.
Step 1: The twig
Start low on the left. Draw a twig up to the right, thinner at the top, stopping near the middle.
Tip Give the bottom end a round cap.
Step 2: The bottom petal
Right of the twig tip, start high: draw a wide dented petal pointing down, stop beside your start.
Tip Dogwood petals have a little notch at the end, like a dent.
Step 3: The side petals
From the same spot draw the same dented petal pointing right, then left, each stopping at the bottom petal.
Step 4: The top petal
Start on the left petal. Draw the fourth petal pointing up and stop on the right petal, finishing the cross.
Step 5: The middle
Where the petals meet draw a small circle. Put a ring of 5 dots inside it.
Step 6: A smaller bloom
Left of the twig, halfway down, draw a smaller dogwood the same way: 4 dented petals round a circle.
Step 7: Two flower stalks
Join each flower to the twig with a short stalk: 2 little lines from the twig to the petals.
Step 8: 2 leaves
From the twig's right side draw 2 short stalks, each ending in a pointed leaf, one below each flower.
Step 9: Leaf veins
In each leaf draw a gently curved line from the stalk almost to the pointed tip.
Step 10: White petals
Go over your lines, then colour all the petals with a white crayon so they stand out.
Step 11: Yellow middles
Colour both flower middles yellow.
Step 12: Brown twig, green leaves
Colour the twig brown, and the 2 stalks and both leaves green. Your dogwood is done!

Your finished drawing
Follow the steps above and this is where you end up: a dogwood flower, drawn by you.
Every step in one picture
