
Watch it draw itself · tap to replay
How to Draw a Circular Saw
Draw a circular saw in 14 easy steps, about 11 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the blade guard.
Step 1: The blade guard
On the left, above the middle, draw a big half circle with a flat bottom.
Tip A circular saw has a big round blade half hidden under a guard.
Step 2: 2 big eyes
On the guard draw 2 big egg eyes. Colour a black dot in each, leaving a white shine.
Step 3: Smile and cheeks
Under the eyes draw a U smile. Add a small oval cheek beside each end.
Step 4: The shoe plate
Under the guard draw a long thin box, from just left of the guard to near the right edge.
Step 5: The motor
Start on the guard's right side. Draw a line out right, round the end, and go down to the plate.
Step 6: The handle
From the guard's top draw a thick handle. Arch it up, then slope it down onto the motor's end.
Tip The gap under the handle is where your hand goes.
Step 7: The round blade
Under the plate draw the bottom of a big round blade. Give it pointy teeth all the way round.
Tip The guard hides the top of the blade, so only the bottom shows.
Step 8: Motor vents
On the motor draw 3 short lines side by side, for the air vents.
Step 9: The plank
Under the plate, from the middle of the blade to the right, draw a thick plank. Add a ground line.
Tip The saw is cutting the end off the plank.
Step 10: The cord
Start at the back of the motor. Draw a short cord curving out and down to the plank.
Step 11: Sparkles
Draw a small four-point sparkle near each top corner, not touching the saw.
Step 12: Tan and pink
Go over your lines, then colour the plank tan around the blade and the cheeks pink. Leave the eyes white.
Step 13: Grey blade, orange saw
Colour the blade and its teeth grey. Colour the guard and the motor orange, around the face.
Step 14: Dark grey handle
Colour the handle and the plate dark grey. Leave the gap under the handle white. Whirr!

Your finished drawing
Follow the steps above and this is where you end up: a circular saw, drawn by you.
Every step in one picture
