
Watch it draw itself · tap to replay
How to Draw a Segway
Draw a Segway in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: handlebar and grips.
Step 1: Handlebar and grips
Near the top, in the middle, draw a flat bar. Add a fat round grip on each end.
Tip Leave lots of paper below: the pole is tall.
Step 2: The straight pole
Under the middle of the bar, draw 2 long lines straight down. Join them a hand above the bottom.
Step 3: The platform
Around the bottom of the pole draw a wide flat board. Add a line along it from end to end.
Step 4: Two big wheels
Over each end of the board draw a tall, fat tyre with round corners, seen from the front.
Tip From the front a wheel looks like a tall rounded box, not a circle.
Step 5: Tyre treads
Across each tyre draw 3 small V lines, from one side of the tyre to the other.
Step 6: Two fenders
Start on each tyre's outside. Draw a thick upside-down U over the top and stop on the tyre's inside.
Step 7: Foot pads
On the top of the board draw 2 flat rounded rectangles, one on each side of the pole.
Step 8: The ground
Start left of the left wheel. Draw a straight line under both wheels and stop past the right wheel.
Step 9: Yellow and light grey
Colour the fenders and the board's top yellow around the pads. Colour the board's front strip light grey.
Step 10: Red grips, blue pole
Colour the 2 grips red, and the pole and the handlebar blue.
Step 11: Dark grey tyres
Colour the tyres and the foot pads dark grey.

Your finished drawing
Follow the steps above and this is where you end up: a Segway, drawn by you.
Every step in one picture
