Watch it draw itself · tap to replay
How to Draw a Juicer
Draw a juicer in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the rim.
Step 1: The rim
Below the middle draw a wide flat oval for the top of the juicer bowl, about a hand across.
Step 2: The bowl
From the oval's left end draw a bowl curve down, round the bottom, and up to the right end.
Step 3: The cone
From the oval left of middle, curve up to a tall point and down to the oval right of middle.
Tip Like a little mountain sitting in the bowl.
Step 4: Ridges
Draw 3 ridges down the cone, from near the point to the oval: one in the middle, one each side.
Step 5: The spout
From the oval's left end go out to a point, then back to the cone. Rub out the oval inside.
Step 6: The foot
Under the bowl draw a short foot: in a little, then flaring out to a flat bottom.
Step 7: Half a lemon
On the left draw a cut half lemon: a circle, a smaller circle inside, and 5 lines from the middle.
Step 8: The table
Draw the table line from the left edge to the right edge, touching the bottom of the foot and lemon.
Step 9: Yellow cone
Go over your lines, then colour the cone yellow, and the inside of the rim and spout too.
Step 10: Yellow lemon
Colour the whole lemon half yellow, rind and all.
Step 11: Sky juicer
Colour the bowl and the foot sky blue, and your juicer is done!
Your finished drawing
Follow the steps above and this is where you end up: a juicer, drawn by you.
Every step in one picture
