Watch it draw itself · tap to replay
How to Draw Ice Pop Molds
Draw ice pop molds in 12 easy steps, about 9 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the stand.
Step 1: The stand
A little below the middle draw a wide low box with soft corners, for the stand.
Step 2: Middle pop
Standing in the middle of the stand draw a tall box with soft top corners, like a fat finger.
Step 3: 2 big eyes
Near the top draw 2 big egg eyes, one eye apart. Colour a black dot in each, leaving a shine.
Step 4: Little smile
Under the eyes draw a small U smile from under the left eye to under the right eye.
Step 5: 2 more pops
On each side draw a shorter pop standing in the stand, the same width, one a bit taller.
Step 6: The sticks
From the top of each pop draw a short thin stick poking straight up.
Step 7: Mold rims
Where each pop meets the stand, draw a flat band a little wider than the pop, for the mold rim.
Step 8: Ground line
Draw a straight ground line under the stand, from near the left edge across to near the right edge.
Step 9: Sparkles
Draw a few little 4-point sparkles around it to make it shine.
Step 10: Yellow and orange
Go over your lines, then colour the sparkles yellow and the 2 side pops orange.
Step 11: Red middle pop
Colour the middle pop red, leaving the eyes white.
Step 12: Wood sticks, purple stand
Colour the sticks wood brown, and the stand and the mold rims purple.
Your finished drawing
Follow the steps above and this is where you end up: ice pop molds, drawn by you.
Every step in one picture
