
Watch it draw itself · tap to replay
How to Draw a Hacksaw
Draw a hacksaw in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the handle.
Step 1: The handle
On the left draw a fat rounded handle, taller than it is wide, with a straight right side.
Tip Leave lots of room on the right for the long frame.
Step 2: Finger hole
Inside the handle draw a tall rounded hole for your fingers, leaning the same way as the handle's back.
Step 3: The frame
From high on the handle draw a long thin bar right, then an arm down. Stop near the handle's bottom.
Step 4: The blade
Start low on the handle. Draw a thin blade, 2 close lines, across to the bottom of the arm.
Step 5: The teeth
Along the bottom of the blade draw zigzag teeth, from the handle across to the arm.
Step 6: A wing nut
On the outside of the arm draw a small circle, with a round wing above it and below it.
Tip This wing nut keeps the blade tight.
Step 7: The plank
Under the saw draw a long flat plank, touching the teeth and the handle.
Step 8: Ground line
Start just left of the plank. Draw a ground line along its bottom, stopping just past its right end.
Step 9: Orange handle, tan plank
Go over your lines. Colour the plank tan and the handle orange, leaving the finger hole empty.
Step 10: Blue frame
Colour the long thin frame blue, from the handle to the bottom of the arm.
Step 11: Grey blade
Colour the blade, teeth and wing nut grey. Your hacksaw is ready to cut!

Your finished drawing
Follow the steps above and this is where you end up: a hacksaw, drawn by you.
Every step in one picture
