Watch it draw itself · tap to replay
How to Draw an Energy Drink
Draw an energy drink in 10 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the can.
Step 1: The can
Start near the top left. Draw a big U, straight down, round the bottom and up to the same height.
Step 2: The neck
From the top of each side, draw a short line curving in and up. Stop a little way in.
Tip Keep the neck narrower than the can, so it looks like a drink can.
Step 3: The rim
Join the 2 neck ends with a flat oval for the rim of the can.
Step 4: The lid
Inside the rim, draw a smaller flat oval for the lid.
Step 5: The pull tab
On the lid, from the middle to the right, draw a flat pill tab with a hole in its end.
Step 6: Lightning bolt
On the can's front, draw a big lightning bolt with a flat top, a zigzag and a sharp point.
Step 7: The table
Start near the left edge and draw a table line along the can's bottom. Stop near the right edge.
Step 8: Yellow bolt
Go over your lines, then colour the lightning bolt yellow.
Step 9: Grey top
Colour the rim, the lid and the pull tab grey.
Step 10: Teal can
Colour the can teal, going around the bolt. Your energy drink is ready. Pssht!
Your finished drawing
Follow the steps above and this is where you end up: an energy drink, drawn by you.
Every step in one picture
