Get the app: iPhone Android
squigglingsToday’s squiggleThemesSaved
Finished drawing of a dirtbike

Watch it draw itself · tap to replay

How to Draw a Dirtbike

13 steps · Medium · about 10 min

Draw a dirtbike in 13 easy steps, about 10 minutes. Free, with a printable worksheet.

Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: two big wheels.

Print

  1. Step 1: Two big wheels

    Low on your paper draw 2 big circles the same size. Inside each draw a smaller circle and a hub.

    Tip Leave a gap between the wheels almost as wide as one wheel.

  2. Step 2: Number plate

    Above the front wheel, a little to the right, draw a soft square number plate with a 1 inside.

  3. Step 3: Fat fork

    Draw a fat tube slanting up from the front hub, behind the plate, to a round top above it.

  4. Step 4: Front fender

    Over the front tyre draw a curved fender with a pointed front. It goes behind the fork.

    Tip Leave a small gap between the fender and the tyre.

  5. Step 5: Gas tank

    Start at the plate. Draw a flat line sloping back, then a round belly curving forward to the fork.

  6. Step 6: Seat and tail

    Draw a long flat seat from the tank over the back wheel. Under its back add a pointed tail.

  7. Step 7: The engine

    Under the tank draw 2 lines down with 3 stripes across. Below, draw a round engine with a circle.

  8. Step 8: Back bar and pipe

    From the engine draw a bar to the back hub, and a pipe sloping up with a fat end.

  9. Step 9: Handlebar

    From the fork top draw a short bar slanting back. Add a fat round grip on its end.

  10. Step 10: Knobby tread

    Round each tyre draw 10 little square bumps sticking out. Each wheel stands on its bottom bump.

    Tip Space the bumps evenly, like the teeth of a gear.

  11. Step 11: Spokes and ground

    In each wheel draw 4 spokes from the hub to the rim, like an X. Draw a ground line under.

  12. Step 12: Yellow and grey

    Go over your lines. Colour the number plate yellow. Colour the metal grey: fork, bars, engine, pipe and hubs.

  13. Step 13: Red and dark grey

    Colour the tank, fender and tail red, around the fork. Colour the tyres, grip and seat dark grey.

Your finished drawing

Follow the steps above and this is where you end up: a dirtbike, drawn by you.

Every step in one picture

How to Draw a Dirtbike step by step: all 13 steps in one picture

More to draw

More vehicles to draw · Every squiggling, A to Z