Watch it draw itself · tap to replay
How to Draw a Bluetooth Speaker
Draw a Bluetooth speaker in 12 easy steps, about 9 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the speaker.
Step 1: The speaker
In the middle draw a long rounded pill lying on its side, nearly as wide as the page.
Tip A little speaker that plays music from your phone with no wires.
Step 2: Two big eyes
On the right half draw 2 big egg eyes. Colour a black dot in each, leaving a white shine.
Step 3: Smile and cheeks
Under the eyes draw a U smile, and a small flat oval cheek beside each end.
Step 4: The grille
On the left half draw 3 rows of 4 little dots for the speaker grille.
Step 5: Buttons
On top, above the face, draw 3 little flat bumps in a row for the buttons.
Step 6: Sound waves
Just past each end draw a curved sound line bowing outwards, from eye level down to smile level.
Step 7: Notes
Draw a music note in the air on each side above the speaker.
Step 8: Ground
Draw a ground line right under the speaker, from left to right.
Step 9: Pink cheeks
Go over your lines, then colour the cheeks pink.
Step 10: Teal speaker
Colour the speaker teal, going around the face and the grille dots. Leave the eyes white.
Step 11: Black dots
Colour the grille dots black.
Step 12: Black buttons and notes
Colour the 3 buttons and the notes black. Turn it up!
Your finished drawing
Follow the steps above and this is where you end up: a Bluetooth speaker, drawn by you.
Every step in one picture
