
Watch it draw itself · tap to replay
How to Draw a 3D Cylinder
Draw a 3D cylinder in 11 easy steps, about 8 minutes. Free, with a printable worksheet.
Each picture adds one red line. Draw that line, then scroll to the next picture. Rub out any dashed helper lines at the end. First up: the top oval.
Step 1: The top oval
Near the top of your paper, draw a flat oval, wider than tall. This is the top of the can.
Tip A cylinder is a tin can: round top, straight sides, round bottom.
Step 2: Sides and bottom
From each oval end, draw a line down as long as the oval is wide. Join them with a smile.
Step 3: Two big eyes
A little above the middle of the can, draw 2 big egg eyes. Add a black dot in each.
Step 4: A big smile
A little under the eyes, draw a big wide U smile from the left eye to the right eye.
Step 5: Rosy cheeks
Beside each end of the smile, leaving a small gap, draw a small sideways oval cheek.
Step 6: Four sparkles
Draw 2 small sparkle stars on each side of the can, one higher and one lower.
Step 7: Floor and shadow
Under the can, draw a floor line well past each side. Add a thin flat oval shadow round the bottom.
Step 8: Yellow sparkles, pink top
Go over your lines. Colour the sparkles yellow, and the top oval and both cheeks pink.
Step 9: Grey shadow
Colour the shadow under the can grey.
Step 10: Red cylinder
Colour the can red around the face, but leave the eyes and a strip down the right side white.
Step 11: Dark red side
Colour that strip dark red, so the can looks round. Your 3D cylinder is done!
Tip The right side is in shade, which makes the can look round.

Your finished drawing
Follow the steps above and this is where you end up: a 3D cylinder, drawn by you.
Every step in one picture
